VWTVWT
← All insights

Check the Empty Truck Before You Load It

Published November 8, 2026 Β· 7 min read

A truck backs onto your dock. The driver hands over the papers. Your team starts putting pallets on. Ninety minutes later the door is closed and the truck leaves.

That was the last moment you could have said no for free. Before the first pallet, a bad truck costs a phone call. After the last pallet, it costs goods.

This article is about a short check on the empty truck, done at your dock, before anything goes on. It takes about five minutes. It will not make the truck roadworthy. It catches the faults that are visible to anyone standing at the back door, and it leaves a record of what condition the truck was in when you accepted it.

Where this fits

Most of what goes wrong with goods in transit is made at a few fixed places, and this is the first of them: the moment between the truck arriving and the load going on. Other articles cover the next steps: choosing a body type for the rain and securing the load once it is on. This one covers the step before both. A good load plan on a wet floor is still a wet load.

What the law gives you, and what it does not

  • The carrier owes you a sound truck. Land Transport Act Section 71 says a vehicle used for transport must be sound and strong and carry the equipment and fittings the Ministerial Regulation requires. Section 148 fines using a vehicle that does not comply, up to 50,000 baht. The duty sits with whoever uses the vehicle.
  • The driver must stop things falling, leaking, smelling or blowing off. Road Traffic Act Section 20 puts this on the driver. It names the outcomes. It does not say how many straps or what cover.
  • Neither section makes you the inspector. You are not asked to certify the truck, and you should not try to. What you can do is refuse a truck that is plainly unfit, and write down that you did.
  • Your own record matters under the Civil and Commercial Code. Section 616 makes a carrier liable for damaged goods unless it proves one of three defences: force majeure, the nature of the goods themselves, or the fault of the sender or consignee. A carrier faced with a wet-cargo claim may say the sender saw the truck and loaded anyway. No Thai ruling on exactly that point was found, so treat this as a risk to manage, not a settled rule. A dated record of what you saw and what you did about it is the cheapest protection for both sides.

The five-minute check

Do it in this order. Each step takes a minute or less.

  1. Match the truck to the booking. Plate, driver name, truck type and body length against what was booked. A different truck than booked is a stop-and-call. The inside width and length matter if your loads are palletised.
  2. Floor. Look for holes, broken boards, protruding nails or bolts, oil, and standing water. A floor that cannot take a pallet corner or a forklift wheel is a reason to refuse.
  3. Walls and roof. Close the door, or stand inside with the door shut, and look for daylight. Light through the roof or walls means rain gets in. For a curtain-sided or open truck, look at the cover itself: tears, patches, missing ties.
  4. Clean, dry, no smell. What did it carry last? Wet, dirty or strongly scented floors damage food, paper and textiles. Standard warehouse practice already treats products that taint each other as something to keep apart, and an empty truck that smells of the last load is the same problem.
  5. Doors, locks and fittings. Do the doors close and lock? Are there lashing points, straps, wedges, edge protectors and a cover if you need one? A load with nothing to hold it down needs fixing before it goes on, not after.

Two things this check is not. It is not a roadworthiness inspection: tyres, brakes and lights belong to the carrier and the yearly state inspection. If you see a flat tyre or a missing light, say so and refuse, but do not put an engine check on your gate team. And it is not a seal check: the seal goes on after loading, and the number is written on the delivery note before the door shuts. At the receiving end, the same number is read against what the sender advised, to learn whether the doors were opened on the way.

Write it down

Three photos and one line. Photo of the plate, photo of the floor and inside, photo of the cover or roof. On the delivery note or the gate log, one line: date, time, plate, "body checked, floor dry and clean, cover in order" or whatever you found. Keep it with the booking.

This takes a minute and does two jobs. It shows you looked. It also lets you see patterns: if one carrier's trucks keep failing on the same point, that goes into the next review with them.

When the truck fails

Decide in advance, because the driver is standing at your dock and a queue is building behind.

Finding Usual action
Dirty or wet floor, can be swept or dried in minutes Fix at the dock, then load. Note it.
Cover torn or missing Refuse, unless the load does not need a cover
Holes in floor or roof Refuse
Strong smell from the last load Refuse for food, paper, textiles. Accept only for goods that cannot taint.
No straps or lashings, load needs them Carrier brings them, or you supply and note it. Do not load without
Wrong truck type or size Stop and call. Do not load and hope

Refusing a truck has a cost on both sides, which is why it should be written into the booking before it happens. Two lines are enough: a truck presented unfit for the cargo is refused without charge to the shipper, and the carrier supplies a replacement within a stated time. Without this, a refused truck turns into an argument about waiting charges or a cancellation fee at the worst moment.

What it costs, as an illustration

The numbers here are made up to show the method.

Say the dock loads 6 trucks a day. At five minutes each, the check is 30 minutes of someone's day, 6 Γ— 5 = 30. Most of it overlaps with the forklift staging the first pallets, so the dock clock hardly moves.

Say one truck in 30 fails. Over a month of 26 loading days that is 6 Γ— 26 = 156 trucks, so about five refusals. Each refusal costs a replacement wait. If that wait is three hours, five refusals cost 15 truck-hours a month in delay. The comparison is a damaged load, which costs the goods, a claim argument and a customer. Use your own counts. The point is to put both columns side by side before deciding whether the check is worth five minutes.

What to do on Monday

  1. Print the five steps on one sheet and put it at the dock office.
  2. Pick who does it. The person who signs the delivery note is the natural choice, because they are already at the truck.
  3. Start taking the three photos on every loaded truck for a month.
  4. Add the two booking lines on unfit trucks to your next contract or booking confirmation.
  5. After a month, count refusals by carrier and by fault. That count is the first honest data you have on carrier equipment quality.

Where the evidence stops: no Thai study on the condition of trucks arriving at a loading dock, or on how often they fail a check, was found. The five steps combine the logic of the receiving practice in a logistics textbook with Thai duties on the driver and carrier. The 1-in-30 failure rate and the three-hour replacement wait are an illustration only. Section 616's reading on a shipper's loading into an accepted truck is untested in anything found here.